ModMyPi LTD | ModMyPi Pi Zero Case Meeting Directions

The laser-cut components of the case are protected by an adhesive movie which must be eliminated earlier than meeting.

Invoice of Supplies

Raspberry Pi Zero 5x Acrylic Plates 4x M2.5 12mm Nylon Screws 4x M2.5 Nylon Nuts

NOTE: Acrylic is a tough and stiff plastic which is delicate to emphasize concentrations and shares a sure degree of fragility with glass. Acrylic can scratch simply and needs to be cleaned with a light resolution of dish detergent and heat water. By no means use cleaners unsuitable for acrylic. By no means use a dry, abrasive material.

NOTE: Earlier than meeting, chances are you'll want to softly take away any extra/left over acrylic residue from the engraved sections. These part are:

4x Nut recess areas 4x Screw recess areas 4x Corners of Pi Zero holding plate

To take away the left over residue, fastidiously scrape the realm with a pointy knife, being cautious to not scratch the encompassing areas.

 

Listed below are the components from the case equipment:

Comply with these photos checking components and orientation of the acrylic items. You will notice a earlier than and after picture for every step. Ensure you have all of the components prepared, proven within the earlier than image.

Make sure that the engraved nut recess' are dealing with down.

Place the Raspberry Pi Zero on prime of the acrylic plate, ensuring the four little solder dots on the underside of the Pi line up with the four minimize outs on the plate.

Make sure that the engraved corners are dealing with down.

Place the acrylic plates on prime of the Pi Zero.

Make sure that the engaving is dealing with up, with the engraved screw recesses dealing with upwards as properly.

Slot every of the screws by means of the holes.

Screw every nut on to every of the screws. Make sure that to not overtighten and that each the nut and screw head have seated accurately into the recess.

It's possible you'll wish to trim the nylon screws down in order that they're flush with the nut. To do that, easy use a pointy knife or perhaps a pair of scissors.

Source link

Read the full article