ModMyPi LTD | Pi-DigiAMP+ ModMyPi Case Meeting Directions

The laser-cut elements of the case are protected by an adhesive movie which must be eliminated earlier than meeting.

Invoice of Supplies

Raspberry Pi B+/2/3 Pi-DigiAMP+ Full-HD Class D Amplifier 6x Acrylic plates 4x 25mm M/F hex stand-offs 4x 12mm F/F hex stand-offs 4x 8mm M/F hex stand-offs 8x M2.5 5mm screws 4x Rubber toes

NOTE: Acrylic is a tough and stiff plastic which is delicate to emphasize concentrations and shares a sure degree of fragility with glass. Acrylic can scratch simply and must be cleaned with a gentle answer of dish detergent and heat water. By no means use cleaners unsuitable for acrylic. By no means use a dry, abrasive material.

Listed below are the elements from the case equipment:

Observe these pictures checking elements and orientation of the acrylic items. You will notice a earlier than and after picture for every step. Be sure you have all of the elements prepared, proven within the earlier than image.

Begin by securing the 4 8mm stand-offs to the underside plate (backside and high plates are the identical) utilizing the screws.

Now place the Pi on to the stand-offs, ensuring the thread of the stand-off undergo the mounting holes on the Pi. Safe with the 4 12mm stand-offs

Now plug the Pi-DigiAMP+ into the Pi's GPIO header and fasten in place utilizing the 25mm stand-offs

Now we have to add every of the aspect plates, one after the other, across the case. Begin with the plate that goes on the USB aspect of the Pi, and work round clockwise. (After the USB plate, do the facility/hdmi aspect plate)

Now we now have all of the aspect plates in place, all we have to do now could be add the highest plate, and safe it in place utilizing the remaining screws!

Source link

Read the full article