ModMyPi LTD | PIco UPS Instances - Normal

The laser-cut components of the case are protected by an adhesive movie which must be eliminated earlier than meeting.

Invoice of Supplies

Raspberry Pi B+/2/3
PIco UPS
14x Black Acrylic Items
2x Clear Acrylic Items
4x M2.5 x 8mm M/F Stand Off
5x M2.5 x 13mm F/F Stand Off
4x M2.5 x 11mm M/F Stand Off
4x M2.5 x 18mm M/F Stand Off
10x M2.5 Black Screw

NOTE: Acrylic is a tough and stiff plastic which is delicate to emphasize concentrations and shares a sure stage of fragility with glass. Acrylic can scratch simply and ought to be cleaned with a gentle answer of dish detergent and heat water. By no means use cleaners unsuitable for acrylic. By no means use a dry, abrasive material.

Listed below are the components from the case equipment:

Observe these pictures checking components and orientation of the acrylic items. You will notice a earlier than and after picture for every step. Ensure you have all of the components prepared, proven within the earlier than image.

Connect the 13mm F/F Stand Offs to the highest of the Pi's mounting holes by inserting the 8mm M/F Stands Off from the underside of the Pi.

Now we have to connect the PIco. Begin by inserting the 40 pin header from the underside of the PIco in order that the pins are dealing with upwards.

Then connect the PIco to the Pi's GPIO header and safe in place utilizing the 11mm M/F Stand Offs.

If you're utilizing the Terminal Block PCB, connect this to the PIco's terminal block header and safe utilizing two of the 18mm M/F Stand Offs. If you're not utilizing the PCB then connect the straight clear acrylic piece.

Now we have to add the battery plate. Merely line up the speaker reduce out with the speaker on the PIco, and the 6 button reduce outs with the buttons. It simply sits there for now, the aspect plates safe it in place in a while.

Then added the curved clear acrylic piece and safe utilizing the remaining two 18mm M/F Stand Offs. Make sure that the clear acrylic curves out, in the direction of the USB ports on the Pi.

Web, plug your battery in and safe to the battery plate utilizing the self adhesive tape on the battery.

Now we're going to begin including the aspect plates. This generally is a little fiddly and requires a little bit of persistence. Begin with the Ethernet/USB port plate.

The the SD Card slot plate.

Then add the GPIO aspect plate.

And at last the USB Energy/HDMI aspect plate.

At this level you may need to put an elastic band across the case to carry it in place.

With the underside plate appropriately aligned flat on the desk. Carry the case up and place on to the underside plate. Fastidiously decide the whole thing up, flip it over and safe the underside plate with 4 black screws.

Connect the remianing 13mm F/F Stand Off to the button holder. Ensure you examine the orientation with the images.

Insert every of the buttons into the button holder, ensuring the little arms of the buttons are on the identical aspect because the stand off.

Then rigorously hooked up the stand off to the highest plate. Make sure that the buttons line up appropriately with the holes within the high plate.

Now we have to safe the highest plate to the remainder of the case. This step is a bit fiddly, however with some wiggling it's going to go collectively.

With the highest of the highest plate dealing with the desk (button legs dealing with up), seize the entire case and flip it over on high of the highest plate.

Begin by aligning the 2 pips the aspect of the buttons.

Fastidiously wiggly the case to get all of the pips across the sides to suit.

Now flip the whole thing over and safe the highest plate utilizing the remaining 4 black screws.

Source link

Read the full article